Have you ever driven into a parking lot or onto a driveway and felt a jarring "thump" where the new asphalt meets the old road? Or worse, have you seen a driveway where the new pavement is higher than the garage floor, creating a funnel for rainwater to enter the house?
These are failures of transition. In professional paving, how we start and end a section of asphalt is just as important as the middle. The technique used to solve these transition problems is called the Butt Joint or Keyway Milling. As a premier provider of asphalt milling services, Black Diamond Paving & Construction considers this step non-negotiable for a quality finish.
The Engineering Problem: Elevation When you add a new layer of asphalt (overlay) to an existing surface, you are adding 2 inches of height.

• The Feather Edge Mistake: Amateur contractors often try to "feather" the new asphalt down to nothing at the edge. They rake the asphalt thin to meet the garage or street.
• Why it Fails: Asphalt relies on aggregate (stone) for strength. You cannot compress a 2-inch stone mix down to zero. The "feather edge" is weak, contains no large stone, and will ravel and break apart within months, leaving a jagged lip.

The Solution: Milling a Keyway Instead of thinning the asphalt, we remove the underlying surface to make room for the full depth of the new material.

• The Process: We use a milling machine (often a smaller, maneuverable Bobcat attachment) to grind a strip of asphalt 4 to 6 feet wide along the transition point (garage, street, sidewalk).
• The Taper: We mill deep (2 inches) at the connection point and taper up to the existing surface level. This creates a "notch" or "key."

The Result: The Butt Joint When we pave the new driveway, the asphalt fills this milled notch.

1. Full Depth: The new asphalt is a consistent 2 inches thick right up to the edge. It maintains its structural integrity.
2. Flush Finish: The top of the new asphalt is perfectly level with your garage floor or the town road. There is no bump.
3. Water Management: Because we removed material near the structure, we can maintain the proper drainage slope, ensuring water runs away from the garage, not into it.

Where Keyways are Essential

• Garage Doors: To prevent flooding.
• Street Aprons: To prevent snowplows from catching the edge of the new driveway and ripping it up.
• Sidewalks: To prevent tripping hazards (ADA compliance).
• Drainage Grates: We mill around catch basins to ensure the grate remains the lowest point for water collection.

Conclusion The difference between a professional paving job and a "fly-by-night" job is often found at the edges. Keyway milling takes extra time and equipment, but it is the only way to ensure a seamless, durable, and safe transition. Demand a proper butt joint for your project, and trust Black Diamond Paving to deliver it.